擠壓態阻燃鈦合金高溫變形行為及機理

擠壓態阻燃鈦合金高溫變形行為及機理Hot deformation behavior and mechanism of as-extruded burn resistant titanium alloy

通過等溫恒應變速率熱模擬壓縮試驗，研究一種擠壓態組織的阻燃鈦合金在變形溫度900~1150 ℃，應變速率0.001~1 s-1條件下的高溫流變應力和組織演變，基于熱壓試驗數據計算變形激活能。結果表明：此種阻燃鈦合金流變應力-應變曲線具有應力峰值和流動軟化特征，高溫變形是擴散控制的過程，軟化機制以動態回復為主，但在應變速率較高時會發生局部連續再結晶，而在應變速率較低時晶界運動比較明顯。

The hot deformation behavior and structural evolution of a burn resistant titanium alloy were studied on the as-extruded samples in the temperature range of 900-1150 ℃ and the strain rate range of 0.001-1 s-1 through the Gleeble-1500 simulator. The deformation activation energy was calculated based on simulation data. The results show that the stress-strain curves exhibit an obvious peak followed by a broad flow softening in higher strain rate ranges. Hot deformation of the burn resistant titanium alloy is lattice diffusion controlled, and dynamic reversion is the primary softening mechanism, while a typical continuous recrystallization will occur at the higher strain rates, and grain boundary migration will occur at lower strain rates.

全文下載：http://pan.baidu.com/s/1dFqzdsd