石墨烯-Cu/Ti6Al4V復合材料的制備及力學性能

石墨烯-Cu/Ti6Al4V復合材料的制備及力學性能Preparation and mechanical properties of GNPs-Cu/Ti6Al4V composites

采用表面無敏化、無活化的化學鍍銅法對石墨烯進行表面鍍銅，并通過微波燒結法(燒結溫度為1000 ℃)制備石墨烯(GNPs)/Ti6Al4V、石墨烯(GNPs)-Cu/Ti6Al4V復合材料，探討石墨烯表面鍍銅后對鈦基復合材料顯微組織和性能的影響。結果表明：石墨烯表面成功鍍覆一層較均勻分布的銅顆粒，石墨烯與基體Ti界面反應嚴重，容易生成粒徑為2~5 μm的TiC；石墨烯表面鍍銅后，界面反應產生的TiC含量增多，同時引入了Ti2Cu相。相比于單純外加石墨烯，石墨烯表面鍍銅后，微量銅降低了燒結溫度，提高了復合材料的力學性能，其致密度、顯微硬度、壓縮強度分別達到96.55%、534HV0.1、1602MPa，室溫磨損機制由基體(Ti6Al4V)的磨粒磨損轉變?yōu)镚NPs-Cu/Ti6Al4V復合材料的粘著磨損。

The copper was plated on the surface of the graphene (GNPs) by chemical copper plating method without sensitization and activation, and the (GNPs)/Ti6Al4V and (GNPs)-Cu/Ti6Al4V composites were prepared by microwave sintering at 1000 ℃. The effects of copper plated GNPs on the microstructure and mechanical properites of Ti matrix composites were investigated. The results show that a layer of the uniform distribution of copper particles is successfully covered on the surface of GNPs. The severe interfacial reaction occurred between the GNPs and Ti, leading to the formation of TiC with the particle size of 2-5 μm. After copper plating, the TiC contents at the interface increase, and the new Ti2Cu phase is also generated. Compared to the (GNPs)/Ti6Al4V composites, the sintering temperature of the (GNPs)-Cu/Ti6Al4V decreases, while the mechanical properties is improved. The density, microhardness and compression strength of (GNPs)-Cu/Ti6Al4V can reach up to 96.55%, 534HV0.1 and 1602 MPa, respectively. At the same time, the wear mechanism changes from abrasive wear for Ti6Al4V sample to adhesive wear for (GNPs)-Cu/Ti6Al4V composites.

全文下載：https://pan.baidu.com/s/1pKCVEjh